Cisco Headend System Release 2.7 Guide De Montage
Appendix C
Direct ASI Installation and Configuration Procedures
112
4013154 Rev C
Install the ASI Package
Installing the ASI Package
After installing the ASI card into the DNCS, follow these instructions to install the
ASI package.
ASI package.
Note: If you have properly followed the instructions in the previous procedure, you
should be logged on as root user to the DNCS.
1 Type . /dvs/dncs/bin/dncsSetup and then press Enter. The system establishes
should be logged on as root user to the DNCS.
1 Type . /dvs/dncs/bin/dncsSetup and then press Enter. The system establishes
the root user environment.
Important! Be sure to type the dot followed by a space prior to typing /dvs.
Important! Be sure to type the dot followed by a space prior to typing /dvs.
2 Insert the CD labeled similarly to SAIasi into the cdrom drive of the DNCS.
3 Type df -n and then press Enter. A list of the mounted filesystems appears.
3 Type df -n and then press Enter. A list of the mounted filesystems appears.
Note: The presence of /cdrom in the output confirms that the system correctly
mounted the CD.
mounted the CD.
4 Type cd /cdrom/cdrom0 and then press Enter.
5 Type install_pkg and then press Enter. Software installs which prepares the
5 Type install_pkg and then press Enter. Software installs which prepares the
DNCS for Direct ASI support.
6 Type eject cd and then press Enter. The CD ejects from the DNCS.
7 Go to Configure the ASI Card (on page 113).
7 Go to Configure the ASI Card (on page 113).