Cisco Headend System Release 2.7 Guide De Montage
Run the Doctor Report
4013154 Rev C
19
Run the Doctor Report
Introduction
Before upgrading the DNCS, run the Doctor Report using the instructions provided
in the DBDS Utilities Version 5.1 Installation Instructions and DNCS Utilities User’s
Guide. The Doctor Report provides key system configuration data that might be
useful before you begin the upgrade process.
in the DBDS Utilities Version 5.1 Installation Instructions and DNCS Utilities User’s
Guide. The Doctor Report provides key system configuration data that might be
useful before you begin the upgrade process.
Notes:
On a typical system, the Doctor Report takes about 10 minutes to run.
Call Cisco Services if the Doctor Report indicates that the database requires
additional data space or temporary space.
additional data space or temporary space.
Analyze the Doctor Report
When you analyze the output of the Doctor Report, be certain that no disk partition
is at over 85 percent capacity. Call Cisco Services if the Doctor Report reveals that a
disk partition is over 85 percent capacity.
is at over 85 percent capacity. Call Cisco Services if the Doctor Report reveals that a
disk partition is over 85 percent capacity.
Also analyze the output of the Doctor Report to verify that the inband
SI_INSERT_RATE is not greater than 0 (zero). If the inband SI_INSERT_RATE is
greater than 0 (zero), refer to Recommendations for Setting System Information to Out-of-
Band, and follow the procedures provided to disable inband SI.
SI_INSERT_RATE is not greater than 0 (zero). If the inband SI_INSERT_RATE is
greater than 0 (zero), refer to Recommendations for Setting System Information to Out-of-
Band, and follow the procedures provided to disable inband SI.
Note: If the inband SI is disabled, then the SI_INSERT_RATE is 0.
Important! Do not go to the next procedure until you have completed running and
analyzing the Doctor Report and correcting any problems it reports.
analyzing the Doctor Report and correcting any problems it reports.