Cisco Cisco WAP150 Wireless-AC N Dual Radio Access Point with PoE Manuel De Maintenance
Single Point Setup
Access Points
Cisco WAP150 and WAP361 Administration Guide
187
11
Access Points
Use the Access Points page to enable or disable Single Point Setup on the WAP
device, view the cluster members, and configure the location and cluster name for
a member. You can also click the IP address of a member to configure and view
data on that device.
device, view the cluster members, and configure the location and cluster name for
a member. You can also click the IP address of a member to configure and view
data on that device.
Configuring the WAP Device for Single Point Setup
To configure the location and name of an individual Single Point Setup cluster
member:
member:
STEP 1
Select Single Point Setup > Access Points.
Single Point Setup is disabled on the WAP device by default. When it is disabled,
the Enable Single Point Setup button is visible. If Single Point Setup is enabled,
the Disable Single Point Setup button is visible. You can edit the Single Point
Setup settings only when Single Point Setup is disabled.
the Enable Single Point Setup button is visible. If Single Point Setup is enabled,
the Disable Single Point Setup button is visible. You can edit the Single Point
Setup settings only when Single Point Setup is disabled.
Icons on the right side of the page indicate whether Single Point Setup is enabled
and, if it is, the number of the WAP devices that are currently joined in the cluster.
and, if it is, the number of the WAP devices that are currently joined in the cluster.
STEP 2
With Single Point Setup disabled, configure these parameters for each individual
member of a Single Point Setup cluster:
member of a Single Point Setup cluster:
•
Location—Enter a description of where the WAP device is physically
located, for example, Reception. The location field is optional. The valid
range is 1 to 64 alphanumeric and special characters.
located, for example, Reception. The location field is optional. The valid
range is 1 to 64 alphanumeric and special characters.
•
Cluster Name—Enter the name of the cluster for the WAP device to join, for
example Reception_Cluster. The cluster name is not sent to other WAP
devices. You must configure the same name on each device that is a
example Reception_Cluster. The cluster name is not sent to other WAP
devices. You must configure the same name on each device that is a
Bandwidth Utilization
Port Settings
Bonjour
VLAN and IPv4
IPv6 Address
WDS Bridge
IPv6 Tunnel
Packet Capture
WorkGroup Bridge