Cisco Cisco WAP150 Wireless-AC N Dual Radio Access Point with PoE Manuel De Maintenance

Administration

Spanning Tree Settings

Cisco WAP150 and WAP361 Administration Guide

NOTE

Changes to the packet capture configuration parameters take affect after the
packet capture is restarted. Modifying the parameters while the packet capture is
running does not affect the current packet capture session. To begin using new
parameter values, an existing packet capture session must be stopped and
restarted.

Local Packet Capture

To initiate a local packet capture:

STEP 1

Select Administration > Packet Capture.

STEP 2

Ensure that Local File is selected for the Packet Capture Method.

STEP 3

Configure these parameters:

•

Capture Interface (For WAP150 Only)—Enter a capture interface type for
packet capture:

Radio1/Radio2—802.11 traffic on the radio interface.

Ethernet—802.3 traffic on the Ethernet port.

Radio 1—VAP0/Radio 2—VAP0—VAP0 traffic.

Radio 1—VAP1 to Radio 1—VAP3 (if configured)—Traffic on the
specified VAP.

Radio 2—VAP1 to Radio 2—VAP3 (if configured)—Traffic on the
specified VAP.

WDS0 to WDS3 (if configured)—Traffic on the specified WDS.

Brtrunk—Linux bridge interface in the WAP device.

•

Capture Interface (For WAP361 Only)—Enter a capture interface type for
packet capture:

Radio1/Radio2—802.11 traffic on the radio interface.

LAN0 to LAN4—802.3 traffic on the Ethernet port.

Radio 1—VAP0/Radio 2—VAP0—VAP0 traffic.

Radio 1—VAP1 to Radio 1—VAP7 (if configured)—Traffic on the
specified VAP.