Cisco Cisco FirePOWER Appliance 7115
Version 5.3
Sourcefire 3D System User Guide
870
Using Application Layer Preprocessors
Decoding FTP and Telnet Traffic
Chapter 23
5. You have two options:
•
Add a new server profile. Click the add icon (
) next to FTP Server on
the left side of the page. The Add Target pop-up window appears.
Specify one or more IP addresses for the client in the Server Address
field and click OK.
You can specify a single IP address or address block, or a
You can specify a single IP address or address block, or a
comma-separated list of either or both. You can specify up to 1024
characters, and you can configure up to 255 policies, including the
default policy. For information on using IPv4 and IPv6 address blocks in
the Sourcefire 3D System, see
A new entry appears in the list of FTP servers on the left side of the
page, highlighted to indicate that it is selected, and the Configuration
section updates to reflect the current configuration for the profile you
added.
•
Modify the settings for an existing server profile. Click the configured
address for a profile you have added under FTP Server on the left side of
the page, or click default.
Your selection is highlighted and the Configuration section updates to
Your selection is highlighted and the Configuration section updates to
display the current configuration for the profile you selected. To delete
an existing profile, click the delete icon (
) next to the profile you want
to remove.
6. Optionally, you can modify any of the following in the Configuration page area:
•
Modify the address or addresses listed in the Networks field and click
any other area of the page.
The highlighted address updates on the left side of the page.
Note that you cannot modify the setting for Network in the default
The highlighted address updates on the left side of the page.
Note that you cannot modify the setting for Network in the default
profile. The default profile applies to all servers on your network that are
not identified in another profile.