SINGER S10 I STUDIO Manuel D'Instructions

Step z

Raise the presser foot. Check that the machine has

not run out of bobbin thread. Rewind bobbin if

needed and replace in bobbin case.

Check that the thread is feeding evenly off of the

thread spool and re-thread the needle.

If the carriage position makes threading the needle

difficult, you can move the hoop for easier

threading by pressing the home position button q.

After rethreading the needle thread, press the

home position button q again to return the carriage

to the previous position.

q Home position button

Step x

Press the stitch back button w or stitch forward button

to move the embroidery hoop to where the thread

broke or quit stitching e. Press the stitch back

once

to move the hoop back by 10 stitches.

  w  Stitch back button
  e  Point of thread breakage
  r  Stitch forward button

When embroidering a design, thread breakage can
occur. Also, the bobbin may run out of thread before the
design is finished.
Follow these steps to re-thread the machine and return
the needle to the position where stitching should resume.

Needle or Bobbin Thread Breaks

Step v

Lower the presser foot. Press the start/stop button

and sew 5 to 6 stitches.

Step b

Press the start/stop button again to stop the

machine. Raise the presser foot. Trim the thread tail

at the beginning of the stitching.

Step n

Lower the presser foot and press the start/stop

button. The machine will sew the first color section

and stop automatically when it has finished.

Step m

Select OK √ and change the thread to its next color.

Sew the next section.

Step ,

Continue sewing and changing threads until the

design is finished. The machine will buzz when

design is complete. Select the OK √ button to return

to the beginning of design.

Step .

Select the exit X button to return to the design

selection screen.

vbn

m,.