Cisco Cisco Prisma II EDR Receiver Guide De Montage
Module Configuration
43
Module Configuration
The module is shipped from the factory with operational parameters set to factory
defaults. However, you will probably choose to configure the operating parameters
so that they are best suited for your application.
defaults. However, you will probably choose to configure the operating parameters
so that they are best suited for your application.
Configuration and Monitoring Methods
The module may be controlled and monitored using any of the following methods.
Prisma II ICIM Front Panel
When a standard Intelligent Communications Interface Module 2 (ICIM2) is
used, its front-panel LCD and keypad interface can be used to configure and
monitor this and other Prisma II modules in the ICIM domain. For instructions
on operating this module using this ICIM, refer to Operation using ICIM (on
page 73).
When a standard Intelligent Communications Interface Module 2 (ICIM2) is
used, its front-panel LCD and keypad interface can be used to configure and
monitor this and other Prisma II modules in the ICIM domain. For instructions
on operating this module using this ICIM, refer to Operation using ICIM (on
page 73).
LCI Software
Local Craft Interface (LCI) software running on a locally connected PC may be
used to configure operating parameters of Prisma II modules. For instructions on
operating this module using LCI software, refer to Operation using LCI (on page
105).
Local Craft Interface (LCI) software running on a locally connected PC may be
used to configure operating parameters of Prisma II modules. For instructions on
operating this module using LCI software, refer to Operation using LCI (on page
105).
CLI Commands
If an ICIM2 or ICIM2-XD is installed, a command line interface (CLI) is available
that can be used to configure and monitor all Prisma II modules in the ICIM
domain. The CLI is available locally (RS-232) or remotely via Telnet. For details,
see the configuration guide for your Prisma II system release.
If an ICIM2 or ICIM2-XD is installed, a command line interface (CLI) is available
that can be used to configure and monitor all Prisma II modules in the ICIM
domain. The CLI is available locally (RS-232) or remotely via Telnet. For details,
see the configuration guide for your Prisma II system release.
ICIM Web Interface
The ICIM Web Interface offers a user-friendly alternative to CLI commands for
remote module setup and monitoring using an ICIM2 or ICIM2-XD. Users
navigate a series of HTML pages through a standard web browser to view and,
where permitted, adjust module parameters. For additional information, see the
configuration guide for your Prisma II system release.
The ICIM Web Interface offers a user-friendly alternative to CLI commands for
remote module setup and monitoring using an ICIM2 or ICIM2-XD. Users
navigate a series of HTML pages through a standard web browser to view and,
where permitted, adjust module parameters. For additional information, see the
configuration guide for your Prisma II system release.