Cisco Cisco Tunnel Terminating Gateway (TTG)
MAP Service Configuration Mode Commands
▀ equipment-identity-register
▄ Command Line Interface Reference, StarOS Release 18
7242
For releases 8.0 and 8.1, the value must be an integer from 1 to 15.
For releases 15.0 and higher, the value must be an integer from 1 to 15.
Important:
This feature requires the enabling of
verify-equipment-identity
for IMEI or IMEISV as
specified with the the
gmm retrieve-equipment-identity imei
command of the call-control-profile
configuration mode.
include-imsi
Enables inclusion of IMSI checking during the IMEI check procedure. By default this function is not
included.
included.
map-include-imsi
Enables the inclusion of IMSI parameter in the CHECK_IMEI Request. By default, IMSI is not included in
the CHECK_IMEI Request.
the CHECK_IMEI Request.
Usage
Configure the identity of the EIR that the SGSN uses and the interaction parameters.
Increasing the
Increasing the
check-imei-every-n-events
frequency enables the EIR to avoid overload as the number
of data-only devices attaching to the network increases.
Example
Configure EIR with point code 1.255.1 to perform IMEI check after every 61st received Attach Request
message:
message:
equipment-identity-register point code 1.255.1 check-imei-every-n-events
62
62
Configure IMSI to be included in the MAP-CHECK-IMEI operation:
equipment-identity-register point code 1.255.1 check-imei-every-n-events
62 include-imsi
62 include-imsi