Cisco Cisco Tunnel Terminating Gateway (TTG)
MPLS-LDP Configuration Mode Commands
discovery ▀
Command Line Interface Reference, StarOS Release 18 ▄
7443
Usage
This is an optional command that is used to configure LDP peer discovery parameters. The LDP discovery
hold-interval is always set to three times the LDP discovery hello-interval. Transport address is the address
used for the TCP session over which LDP is running. If the transport address is not configured, the LDP
router-id is used as transport address. Any update to transport address will take effect only if LDP is disabled
and re-enabled. The “default” option sets the hello intervals to the default values.
hold-interval is always set to three times the LDP discovery hello-interval. Transport address is the address
used for the TCP session over which LDP is running. If the transport address is not configured, the LDP
router-id is used as transport address. Any update to transport address will take effect only if LDP is disabled
and re-enabled. The “default” option sets the hello intervals to the default values.
Example
The following command sequence configures the LDP peer discovery parameters:
discovery hello hello-interval 10
discovery hello hold-interval 30
discovery transport-address 10.2.3.4