Cisco Cisco Tunnel Terminating Gateway (TTG)
SGSN Service Configuration Mode Commands
▀ associate
▄ Command Line Interface Reference, StarOS Release 18
8632
context
ctx_name
Identifies a specific context name where the named service is configured. If this keyword is omitted, the
named service must exist in the same context as the SGSN service.
named service must exist in the same context as the SGSN service.
ctx_name
is name of the configured context of the named service expressed as an alphanumeric string of 1
through 63 characters that is case sensitive.
tai-mgmt-db database_name
Associates this SGSN service with a pre-configured TAI Management Database.
database_name
specifies the name of a pre-configured TAI Management Database to associate with the
SGSN service as alphanumeric string of 1 through 64 characters. For more information, refer to the tai-
mgmt-db command in the LTE Policy Configuration Mode Commands chapter and the LTE TAI
Management Database Configuration Mode Commands chapter.
This command is available on the SGSN only if the SGSN S4 Interface license is enabled.
mgmt-db command in the LTE Policy Configuration Mode Commands chapter and the LTE TAI
Management Database Configuration Mode Commands chapter.
This command is available on the SGSN only if the SGSN S4 Interface license is enabled.
Usage
Use this command to associate a pre-configured service or policy with an SGSN service.
The eGTP service provides eGTP-C protocol interface support between EPS nodes. For more information on
the eGTP service and the supported interface type, refer to the eGTP Service Configuration Mode Commands
chapter.
The eGTP service provides eGTP-C protocol interface support between EPS nodes. For more information on
the eGTP service and the supported interface type, refer to the eGTP Service Configuration Mode Commands
chapter.
Important:
Only one eGTP service can be associated with a service. The eGTP service should be configured
prior to issuing this command.
The HSS peer service provides S6d and S13-prime interface support via the Diameter protocol between the
SGSN and an HSS (S6d) or EIR (S13-prime). For more information on HSS peer service and other
parameters, refer to the HSS Peer Service Configuration Mode Commands chapter.
SGSN and an HSS (S6d) or EIR (S13-prime). For more information on HSS peer service and other
parameters, refer to the HSS Peer Service Configuration Mode Commands chapter.
Important:
Only one HSS peer service can be associated to a service in this release. The HSS peer service
should be configured prior to issuing this command.
Caution:
This is a critical configuration. The SGSN service cannot be started without this configuration. Any
change to this configuration would lead to restarting the SGSN service. Removing or disabling this configuration will
stop the SGSN service.
stop the SGSN service.
Example
The following command associates a pre-configured eGTP service called
egtp1
in the
dst_ctx
context to
an SGSN service:
associate egtp-service egtp1 context dst_ctx
The following command associates a pre-configured HSS peer service called
hss1
in the same context as
SGSN service to an SGSN service:
associate hss-peer-service hss1