Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch

Release Notes for 200, 300, 500, and ESW2 Series Switches Firmware Version 1.2.9

Release Notes

Problem:

Egress rate shaping does not work as expected. Configuring egress

shape on Gigabit ports or on Combo ports between 64k to 5000k, will always
result in 2 Million Bits. This is resolved with the new hardware release 1.1.1.8. It still
exists on HW V01. It also does not work on SG300-52/52P & SG200-52/52P
switches. (CQ123397 and CQ130715)

Solution:

There is no workaround.

Problem:

SNTP synchronization error messages are not logged when an

incorrect MD5 key leads to the loss of synchronization. (CQ132636)

Solution:

There is no workaround for broadcast messages. For Unicast servers,

in the SNTP server table the status message will either say "In process" or "Down"
for those servers that have failed authentication.

Problem:

The Cisco phone model 7960 (a legacy powered device) cannot

power-up when using a cross-over cable.

Solution:

Use straight cable instead.

Problem:

The routing resource "Used number of hosts" is not displayed correctly.

This is just a display issue, there is no user impact. (CQ 133802)

Solution:

There is no workaround.

The following defects are carried forward for the 500 series
switches:

The following known limitations are acknowledged in release 1.2.0.97:

Problem:

Slave and backup switches are rebooted when changing the topology

multiple times. (CQ134655)

Solution:

Avoid changing the topology from ring to chain across multiple

members of the stack.

Problem:

Some strings are not localized on the smartport page. (CQ135604)

Solution:

There is no workaround.

Problem:

For some of the web-based configuration pages to operate correctly,

Java runtime environment needs to be installed. Java applets might not be
displayed correctly. (no bug number)

Solution:

Install the latest Java runtime environment (JRE).