Cisco Cisco SG200-26P 26-port Gigabit PoE Smart Switch
Release Notes for 200, 300, 500, and ESW2 Series Switches Firmware Version 1.2.9
7
Release Notes
Major Changes and Defects Corrected
Major Changes
•
Added Time Zone Acronym and Time Zone from DHCP fields to Configuring
System Time.
System Time.
•
Fan Direction, Alarm Temperature and Temperature fields were added in the
Health screens in Monitoring Fan Status.
Health screens in Monitoring Fan Status.
•
Added delayed reboot option in Rebooting the Switch.
•
Added time range fields to Configuring LAG Settings.
•
Added Power Saving by Disabling Port LEDs.
•
Added Time-Range to Settings for Configuring PoE Settings.
•
TACACS+ accounting added.
•
VLAN Alternate Assignment in Defining 802.1X Port Authentication added.
•
Added SYN Protection field to Security Suite Settings.
•
Added Ingress Committed Burst Size (CBS) field to Configuring Bandwidth.
Defects Corrected
•
Whenever the Short Reach option is checked on a given port, the EEE
option is grayed out but EEE LLDP is not. However, when checked and then
the apply button is pressed, the correct error message is being displayed.
(CQ132049)
option is grayed out but EEE LLDP is not. However, when checked and then
the apply button is pressed, the correct error message is being displayed.
(CQ132049)
•
Login fails when using the”+”' character at the end of a Username or
Password. (CQ132366)
Password. (CQ132366)
•
The backup switch in the stack continuously reboots after a new master
takes over when it is hot inserted into stack. (CQ135359)
takes over when it is hot inserted into stack. (CQ135359)