Cisco Cisco IOS XE 3.5E Manuel Technique
QoS on Converged Access Controllers and
Lightweight APs Configuration Example
Lightweight APs Configuration Example
Document ID: 116479
Contributed by Jerome Henry, Cisco TAC Engineer.
Jun 19, 2014
Jun 19, 2014
Contents
Introduction
Prerequisites
Requirements
Components Used
Background Information
L3 QoS Packet Marking Enhancements
Configure Wireless Network for QoS with MQC
Default Hardcoded Policies
Platinum
Gold
Silver
Bronze
Configure Manually
Step 1: Identification and Marking of Voice Traffic
Step 2: Bandwidth and Priority Management at Port Level
Step 3: Bandwidth and Priority Management at SSID Level
Step 4: Call Limitation with CAC
Verify
show class−map
show policy−map
show wlan
show policy−map interface
show platform qos policies
show wireless client mac−address <mac> service−policy
Troubleshoot
Prerequisites
Requirements
Components Used
Background Information
L3 QoS Packet Marking Enhancements
Configure Wireless Network for QoS with MQC
Default Hardcoded Policies
Platinum
Gold
Silver
Bronze
Configure Manually
Step 1: Identification and Marking of Voice Traffic
Step 2: Bandwidth and Priority Management at Port Level
Step 3: Bandwidth and Priority Management at SSID Level
Step 4: Call Limitation with CAC
Verify
show class−map
show policy−map
show wlan
show policy−map interface
show platform qos policies
show wireless client mac−address <mac> service−policy
Troubleshoot
Introduction
This document describes how to configure QoS in a Cisco converged access network with Lightweight
Access Points (LAPs) and with the Cisco Catalyst 3850 switch or the Cisco 5760 Wireless LAN controller
(WLC).
Access Points (LAPs) and with the Cisco Catalyst 3850 switch or the Cisco 5760 Wireless LAN controller
(WLC).
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Basic knowledge of how to configure LAPs and Cisco converged access controllers
•
Knowledge of how to configure basic routing and QoS in a wired network
•