Cisco Cisco Web Security Appliance S680 Guide De Montage

Plug the Ethernet cables into the appropriate ports on the back 
panel of the Cisco S390 appliance.

The proxy ports are labeled P1 and P2.

P1 only enabled: When only P1 is enabled, connect it to 
the network for both incoming and outgoing traffic.

P1 and P2 enabled: When both P1 and P2 are enabled, 
you must connect P1 to the internal network and P2 to 
the Internet.

The traffic monitor ports are labeled T1 and T2.

Simplex tap: Ports T1 and T2; one cable for all packets 
destined for the Internet (T1) and one cable for all 
packets coming from the Internet (T2).

Duplex tap: Port T1; one cable for all incoming and 
outgoing traffic.

Connect your laptop to the Management Port using the 
Ethernet cable included in the system box. The S-Series 
appliance uses the M1 Management Port only.

1

Proxy port 1 Connect proxy port P1 to the 

network for both incoming and 
outgoing traffic.

2

Proxy port 2 When both proxy ports P1 and P2 

are enabled, you must connect P1 to 
the internal network and P2 to the 
Internet. P1 and P2 can connect to L4 
switch, WCCP router, or network 
switch.