Cisco Cisco Web Security Appliance S660 Mode D'Emploi

Connect the Appliance to networks and devices. 

Complete the System Setup Wizard worksheet.

.

If you are preparing to run the System Setup Wizard on a virtual appliance, use the 

loadlicense

 

command to load the virtual appliance license. For complete information, see the Cisco Content 
Security Virtual Appliance Installation Guide, available from 

Note that reference information for each configuration item used in the System Setup Wizard is 
available at 

Open a browser and enter the IP address of the Web Security appliance. The first time you run the System 
Setup Wizard, use the default IP address:

https://192.168.42.42:8443

 

-or-

http://192.168.42.42:8080

 

where 

192.168.42.42 

is the default IP address, and

 8080 

is the default admin port setting for HTTP, 

and 

8443

 is default admin port for HTTPS.

Otherwise, if the appliance is currently configured, use the IP address of the M1 port.

When the appliance login screen appears, enter the username and password to access the appliance. By 
default, the appliance ships with the following username and password:

Username: 

Password: ironport

Choose System Administration > System Setup Wizard.

If the appliance is already configured, you will be warned that you are about to reset the configuration. 
To continue with the System Setup Wizard, click the Reset Configuration button. The appliance will 
reset and the browser will refresh to the appliance home screen. Begin again at 

Read and accept the terms of the end user license agreement. 

Click Begin Setup to continue.

Configure all settings using the provided reference tables as required.

Review the configuration information. If you need to change an option, click the Edit button for that 
section.

Click Install This Configuration.