Cisco Cisco ACE Application Control Engine Module Manuel Technique

!−−− FT group used for the load balancing context C1.

username admin password 5 $1$faXJEFBj$TJR1Nx7sLPTi5BZ97v08c/ role Admin domai

n default−domain

username www password 5 $1$UZIiwUk7$QMVYN1JASaycabrHkhGcS/ role Admin domain

default−domain

switch/Admin#

Router Configuration

!−−− Only portions of the config relevant

!−−− to the ACE are displayed.

sf−cat1−7606#show run

Building configuration...

!−−− Output Omitted.

svclc multiple−vlan−interfaces

svclc module 2 vlan−group 2

svclc vlan−group 2 220,240,250,510,511,520,540,550

!−−− Before the ACE can receive traffic

!−−− from the supervisor engine in the Catalyst 6500

!−−− or Cisco 6600 series router, you must

!−−− create VLAN groups on the supervisor engine,

!−−− and then assign the groups to the ACE.

!−−− Add vlans to the vlan−group that are needed

!−−− for ALL contexts on the ACE.

interface Vlan240

description public−vip−172.16.0.x

ip address 172.16.0.2 255.255.255.0

standby ip 172.16.0.1

standby priority 20

standby name ACE_slot2

!−−− SVI (Switch Virtual Interface).

!−−− The standby address is the default gateway for the ACE.

!−−− Output Omitted.

sf−cat1−7606#

Verify

Use this section to confirm that your configuration works properly.