Cisco Cisco Catalyst 6000 Multilayer Switch Feature Card MSFC2 Guide De Montage
Connecting Cisco High-Density Extension Modules to the Network
Installing Expansion Modules on Cisco High-Density Extension Modules
4
Connecting Cisco High-Density Extension Modules to the Network
The 8-port analog voice/fax expansion module (EM-HDA-8FXS and EM3-HDA-8FXS) adds an
additional eight FXS ports to the Cisco high-density extension module.
additional eight FXS ports to the Cisco high-density extension module.
Tip
When router power is off, connect an analog phone to the FXO line to make a call. (See the
for more information).
Note
If you have specified the use of a private line automatic ringdown (PLAR) off-premises extension (OPX)
connection mode for an FXO voice port (with loop resistance less than 8000 Ohm), you must ensure
that the soft-offhook option is enabled on the port.
connection mode for an FXO voice port (with loop resistance less than 8000 Ohm), you must ensure
that the soft-offhook option is enabled on the port.
This option allows a stepped offhook resistance during seizure which avoids overloading the circuit
during offhook in the event that ringing voltage is present on the circuit at the same time as the trunk
seizure. The stepped offhook resistance is initially set to 800 Ohms, then adjusts to 50 Ohms when
ringing voltage is not present.
during offhook in the event that ringing voltage is present on the circuit at the same time as the trunk
seizure. The stepped offhook resistance is initially set to 800 Ohms, then adjusts to 50 Ohms when
ringing voltage is not present.
To enable soft-offhook command on the port, and to access the connection command with plar opx
syntax, see the
syntax, see the
Installing Expansion Modules on Cisco High-Density Extension
Modules
Modules
Expansion modules can be used to increase the number of ports supported on the high-density extension
module.
module.
Note
ESD straps should be worn when handling all modules, including during installation of expansion
modules. An ESD wrist strap is shipped with the product.
modules. An ESD wrist strap is shipped with the product.
To install expansion modules, follow these steps:
Step 1
Decide if the expansion board is going in the EM0 slot or EM1 slot.
Note
The EM0 slot is on the left, and the EM1 slot is on the right as you look at the face plate.
Step 2
Align the connectors on the underside of the expansion module with the connectors for the slot you plan
to use on the network module. (See
to use on the network module. (See
Step 3
Using gentle pressure, insert the connectors on the underside of the expansion module into the
connectors on the network module.
connectors on the network module.
Tip
Use the alignment pins on the network module brackets to guide the expansion module during
installation.
installation.