Cisco Cisco SM-X Layer 2 3 EtherSwitch Service Module
Cisco SM-X Layer 2/3 EtherSwitch Service Module (ESM) Configuration Guide for Cisco 2900 and Cisco 3900 Series
Upgrading the Cisco SM-X Layer 2/3 ESM Software
16
Cisco SM-X Layer 2/3 EtherSwitch Service Module (ESM) Configuration Guide for Cisco 2900 and Cisco 3900 Series ISRs
Upgrading the Cisco SM-X Layer 2/3 ESM Software
You can copy the switch image to the ESM flash by following one of the two methods listed below:
•
Establish connectivity from your ESM’s front panel port to the TFTP server where the desired
switch Cisco.com image is stored
switch Cisco.com image is stored
•
Copy the switch image (available on Cisco.com) to the router’s flash and copy this image to ESM
flash through TFTP.]
flash through TFTP.]
Copying Switch Image Directly to ESM flash Through TFTP Server
This section describes how to copy a switch image directly to the ESM flash through the TFTP server.