Cisco Cisco Customer Voice Portal Downloads
Figure 6: Call Management Administration - Defining a Trunk
Note: SIP is automatically selected for device protocol.
Click Next.
Step 7
The next Trunk Configuration window has many sections. Configure only the following items:
a.
In the Device Information section:
Device Name: VoiceGateway
Description: Gateway trunk for standalone exercises
Device Pool: Select Default from the drop-down menu.
b.
In the SIP Information section:
Destination Address: Enter the IP address of the voice gateway.
SIP Trunk Security Profile: From the drop-down menu, select Non Secure SIP Trunk Profile.
SIP Profile: From the drop-down menu, select Standard SIP Profile.
Step 8
Click Save to save the definition.
Click OK at the reset prompt. You will do this later.
You should see a message Add Successful. If you did not enter all the required items, the wizard
will prompt you to correct specific entries.
will prompt you to correct specific entries.
Step 9
Click Reset to display the Device Reset window. Click Reset on this window to make the
changes effective.
changes effective.
Getting Started with Cisco Unified Customer Voice Portal Release 8.0(0)
28
Chapter 3: Exercise Prerequisites
Modify the Exercises to Use a VoIP Phone through Unified Communications Manager