Cisco Cisco TelePresence MX700 Guide De Montage
D14639.05 Video Systems Getting Started Guide (TC5.0) | 2011 NOVEMBER | © 2011 Cisco Systems, Inc. All rights reserved.
www.cisco.com
21
GettinG started Guide
remote control and on-screen menu
Configuring IP
(when not set by a provisioning system)
Your video conference system supports both IP version 4
(IPv4) and IP version 6 (IPv6).
In both cases, the IP parameters can be assigned
automatically by the network, or you can set everything
manually.
If you want to set the parameters manually please
contact your network administrator to obtain the required
parameters.
If an IP address is already assigned to your system, you will
find the current IPv4 and/or IPv6 address on the System
Information page:
Go to
Home > Settings > System information
.
The IPv4 Address and/or IPv6 Address of the system
is shown in the NETWORK
section on the System
Information page.
Press
Press
Exit
(the right most function key) to exit.
1. Select IP version
i. Go to
Home > Settings > Administrator settings > IP
settings
.
ii. Select
IPv4
or
IPv6
in the
IP version
drop down list
according to your requirement.
2. Select automatic or manual IP assignment
i. Go to
Configure > IP assignment
.
ii. Select
DHCP
(IPv4) or
Autoconf
(IPv6) in the
IP
assignment
drop down list if you want automatic IP
assignment; select
Static
if you want to set the IP
addresses manually.
iii. Navigate to
OK
to save the change, or
Cancel
to leave
without saving. Press
OK
( )
to confirm.
3. Set the IP addresses
Set the remaining IP settings according to the table to
the right. The actions required depend on the IP version
and IP assignment method you selected in the previous
steps.
4. Return to the main menu
Press
Home
( )
to return to the home menu.
IP assignment
IP version
DHCP/Autoconf
Static
IPv4
The IP configuration is complete.
a. Go to
Configure
and enter the
IP Address
,
Subnet Mask
,
Gateway
, and
DNS Server
.
IPv6
a. Go to Configure, and set
DHCP Options
to
On
or
Off
according to your preference.
1
b. Navigate to
OK
to save the change, or
Cancel
to leave without saving.
a. Go to Configure, and enter the
IP Address
and
Gateway
.
b. Set
DHCPOptions
to
On
or
Off
according to
your preference.
1
c. Navigate to
OK
to save the change or
Cancel
to leave without saving.
1
DHCP Options:
Off: All IP parameters, except the IP address and gateway, must be set manually.
Please refer to the Administrator Guide for your product for details about all settings.
On: The IP parameters, like the DNS and NTP server addresses, will be obtained automatically from the network.
Please refer to the Administrator Guide for your product for details about all settings.
On: The IP parameters, like the DNS and NTP server addresses, will be obtained automatically from the network.
Always save the new value when you change a
setting
• Drop down list selection: Navigate to the correct
value and press the
OK
( )
key to save, or press
the left arrow key to leave without saving.
• Text entry in an input field: Enter the text, navigate
to
Ok/Save
to save the change, or navigate to
Cancel
to leave without saving; then press the
OK
( ) key
to confirm.
Back to task overview
User interfaces
Introduction
Configuration
Table of contents
Appendices
Configuration