Cisco Cisco TelePresence MX700 Manuel De Maintenance
D15331.01 MX700 and MX800 Administrator Guide CE8.0, NOVEMBER 2015.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
163
Cisco TelePresence MX700 and MX800
Administrator Guide
Standard COM-port
(9-pin, female)
Remove the left side
cover to get access to
the connectors.
Computer
Video
system
USB
COM
(9-pin, male)
COM
(9-pin, male)
COM
(9-pin, female)
RS-232 adapter
Serial cable
Serial interface (RS-232)
MX700 and MX800 have a standard COM-port for serial
communication. Connect a standard 9-pin RS-232 serial cable
to the COM-port. If the computer does not have a standard serial
connector, you need an RS-232 adapter on the computer side.
The serial connection can be used without an IP-address, DNS, or
a network.
Parameters:
• Baud rate: Configurable. Default 115200 bps
• Data bits: 8
• Parity: None
• Stop bit: 1
• Data bits: 8
• Parity: None
• Stop bit: 1
Video system settings
Serial communication is enabled by default. Use the following
configuration to change the behavior:
SerialPort > Mode
For security reasons, you are asked to sign in before using the
serial interface. Use the following setting to change the behavior:
SerialPort > LoginRequired
We recommend using the default baud rate because the video
system may give much feedback. Use the following setting if you
want to adjust the baud rate.
SerialPort > BaudRate
Restart the video system when you have made changes to the
serial port settings.
Introduction
Configuration
Peripherals
Maintenance
System settings
Appendices
Appendices