Cisco Cisco Content Security Management Appliance M1070 Guide De Montage
4
5
Install the Appliance in a Rack
Install the Cisco M390 Content Security Management
Appliance following the instructions in the Cisco x90 Series
Content Security Appliances Installation and Maintenance
Guide.
Appliance following the instructions in the Cisco x90 Series
Content Security Appliances Installation and Maintenance
Guide.
Appliance Placement
•
Ambient Temperature—To prevent the appliance from
overheating, do not operate it in an area that exceeds an
ambient temperature of 104°F (40°C).
overheating, do not operate it in an area that exceeds an
ambient temperature of 104°F (40°C).
•
Air Flow—Be sure that there is adequate air flow around
the appliance.
the appliance.
•
Mechanical Loading—Be sure that the appliance is level
and stable to avoid any hazardous conditions.
and stable to avoid any hazardous conditions.
6
Temporarily Change Your IP
Address for Remote Access
To remotely configure the Cisco M390 using the network
connection, you must temporarily change the IP address of your
computer. Alternatively, you can use the serial console to
configure the Cisco M390, without changing the IP address. If
you use the serial console, proceed to section
connection, you must temporarily change the IP address of your
computer. Alternatively, you can use the serial console to
configure the Cisco M390, without changing the IP address. If
you use the serial console, proceed to section
below.
AutoSupport:
Enable/Disable
Network Settings
Fully Qualified Appliance Hostname
IP Address
Network Mask:
Default Gateway (Router) IP Address:
DNS (Use the Internet’s root DNS servers or
specify your own):
specify your own):
System Settings
M390_QSG.fm Page 4 Thursday, March 24, 2016 11:25 AM