Cisco Cisco Content Security Management Appliance M1070 Mode D'Emploi

If you attempt to load a configuration file that contains a log subscription that requires a password (for 
example, one that will use FTP push), the 

loadconfig

 command does not warn you about the missing 

password. The FTP push fails and alerts are generated until you configure the correct password using the 

logconfig

 command. 

The “encoding” attribute of the XML configuration file must be “

ISO-8859-1

” regardless of the 

character set you may be using to manipulate the file offline. The encoding attribute is specified in the 
file whenever you issue the 

showconfig

, 

saveconfig

, or 

mailconfig

 command: 

<?xml version="1.0" encoding="ISO-8859-1"?>

Currently, only configuration files with this encoding can be loaded. 

Resetting the current configuration causes your Cisco Content Security appliance to revert settings back 
to the original factory defaults. Save your configuration prior to resetting it. 

See 

. 

You can roll back the configuration to a previously-committed configuration. 

Use the 

rollbackconfig

 command in the command line interface to choose one of the ten most recent 

commits. 

If you enter 

No

 when prompted to commit a rollback, the rollback will be committed the next time you 

commit changes. 

Only users with Administrator access can use the 

rollbackconfig

 command. 

No log messages or alerts will be generated when a previous configuration is restored. 

Certain commits, such as re-allocating disk space to a size insufficient to hold existing data, could result 
in data loss .

The following commands enable you to manipulate the configuration files: 

showconfig

mailconfig

saveconfig

loadconfig

rollbackconfig