Cisco Cisco Content Security Management Appliance M1070 Mode D'Emploi
3-2
AsyncOS 8.1 for Cisco Content Security Management User Guide
Chapter 3 Working With Reports
Note
For differences between logging and reporting, see
How the Security Appliance Gathers Data for Reports
The Security Management appliance pulls data for all reports from all managed appliances
approximately every 15 minutes and aggregates the data from these appliances. Depending on your
appliance, it may take awhile for a particular message to be included in the reporting data on the Security
Management appliance. Check the System Status page for information on your data.
approximately every 15 minutes and aggregates the data from these appliances. Depending on your
appliance, it may take awhile for a particular message to be included in the reporting data on the Security
Management appliance. Check the System Status page for information on your data.
Note
When gathering data for reports, the Security Management appliance applies the time stamp from the
information that was set when you configured the time settings on the Security Management appliance.
For information on setting the time on your Security Management appliance, see the
information that was set when you configured the time settings on the Security Management appliance.
For information on setting the time on your Security Management appliance, see the
.
How Reporting Data is Stored
All of the appliances store reporting data.
shows what time periods that each appliance stores
data.
Export raw data as a CSV (Comma-separated
values) file
values) file
•
•
Generate a PDF of report data
Email report information to yourself and other
people
people
•
•
•
.
•
View archived copies of scheduled and on-demand
reports until they are purged from the system
reports until they are purged from the system
Find information about specific transactions
•
Table 3-1
Ways To View Reporting Data
To See