Cisco Cisco Content Security Management Appliance M1070 Mode D'Emploi
Chapter 11 Common Administrative Tasks
11-16
Cisco IronPort AsyncOS 7.2.0 for Security Management User Guide
OL-21768-01
Upgrading to New Security Management Appliance
Hardware
Hardware
If you are upgrading from an older Security Management appliance to a newer
model, for example, upgrading from an M160 to an M650, perform the following
steps to transfer the data from the older appliance to the new appliance
successfully.
model, for example, upgrading from an M160 to an M650, perform the following
steps to transfer the data from the older appliance to the new appliance
successfully.
Note
It is important to remember that while it is possible to transfer data between
Security Management appliances that are different sizes, the new appliance must
have the same size allocations or greater.
Security Management appliances that are different sizes, the new appliance must
have the same size allocations or greater.
Figure 11-2
Upgrading to a New Security Management Appliance
Hardware
Hardware
Note
All directions listed below are to be typed at the command prompt.
Step 1
Login, as administrator, to any SSH session.
Step 2
At the command prompt, type backupconfig and press Enter.
Choose the operation you want to perform:
•
View—Allows you to view the scheduled backups
•
Verify—Verifies whether the backup can be scheduled to a remote machine.
•
Schedule—Allows you to schedule a backup to an appliance.
•
Cancel—Cancels a scheduled backup.
M160
(source)
M650
(target)
data