Cisco Cisco IOS Software Release 12.0 S

Page de 500
1914
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Resolved Caveats—Cisco IOS Release 12.0(24)S
Conditions: The conditions under which this symptom occurs are not known at this time.
Workaround: There is no workaround. 
CSCuk37799
Symptoms: A Cisco 12000 series IP Service Engine (ISE) line card reloads when you exceed the 
hardware limitation during the configuration of an access control list (ACL).
Conditions: This symptom is observed after you have first attached the ACL to several Frame Relay 
subinterfaces.
Workaround: First configure the ACL, and then attach it to the subinterfaces. 
CSCuk37975
Symptom: A router may reload while applying an Access Control List (ACL) to forwarded traffic 
via the ipv6 traffic-filter interface configuration command.
Conditions: This symptom is observed when you enter illegal syntax in the submode of the ipv6 
access-list
 global configuration command.
Workaround: Do not enter illegal syntax in the submode of the ipv6 access-list global configuration 
command. 
CSCuk38075
Symptoms: Web Cache Communication Protocol (WCCP) does not function properly when Cisco 
Express Forwarding (CEF) is enabled. Bypass packets from the cache engine are dropped instead of 
being forwarded.
Conditions: This symptom is observed when both WCCP and CEF are enabled.
Workaround: Disable CEF on the router, and rely on IP fast switching. 
CSCuk39189
Symptoms: Leaks may be observed for some Virtual Private Network (VPN) routing and forwarding 
(VRF) routes in the global Forwarding Information Base (FIB) table when a VRF is deleted and 
recreated. 
Conditions: This symptom is observed on a Cisco router that is running Cisco IOS Release 12.0 S 
or Release 12.2 T. 
Workaround: There is no workaround. 
CSCuk39337
Symptoms: Virtual Private Network routing and forwarding (VRF) does not function properly on a 
Frame Relay link between a provider edge (PE) router and a customer edge (CE) router, and the CE 
router cannot ping the PE router.
Conditions: These symptoms are observed on a Frame Relay link between a Cisco 10000 series 
router that is functioning as a PE router and another Cisco 10000 series router that is functioning as 
a CE router.
Workaround: Reload the PE router to make the link between the PE router and the CE router 
function. 
CSCuk40086
Symptoms: A Cisco 12000 series Internet router may reload when loading a configuration with 1000 
frame-relay sub-interfaces and 2000 IPv6 static routes.