Cisco Cisco IOS Software Release 12.4(4)T

Page de 302
1055
Caveats for Cisco IOS Release 12.4T
OL-8003-09 Rev. Z0
  Resolved Caveats—Cisco IOS Release 12.4(11)T
CSCek56370
Symptoms: In Cisco IOS Release 12.4(10.5)PI5 release testing for AAA RADIUS Server Load 
Balancing Feature, the CLI “load-balance method least-outstanding” is not getting accepted in 
server group config. The same CLI is accepted in Cisco IOS Release 12.4(10.1)PI5 release.
Conditions: This symptom has been observed in Cisco IOS Release 12.4(10.5)PI5 release testing.
Workaround: There is no workaround. 
CSCek60353
*7200/7301: Need to include boot/kboot images.
CSCin99755
Symptoms: Cisco router running PDSN software sends incorrect value for Acct-Session-Time in 
Accounting Stop Messages. This may lead to over charging.
Conditions: The over charging happens when Acct-Session-Time is used for charging the user. Also 
this happens only if there are any interim acct start-stop messages (caused due to change in airlink 
parameters or handoff) sent for the session.
Workaround: G8 can be used for charging.
Further Problem Description: When Acct-Session-Time is used for charging, PDSN will not reset 
the value after sending the interim acct stop messages. So, it will lead to over charging. 
CSCsd90875
Symptoms: A Cisco 3745 router will crash with ipsla_rtp_cfg test after starting ip sla schedule with 
Cisco IOS Release 12.4(7.18)T release.
Conditions: The router will crash after issuing the below configuration: 
conf t
controller T1 1/0
ds0-group 0 timeslots 1 type none
ds0-group 1 timeslots 2 type none
ds0-group 2 timeslots 3 type none
ip sla 1
voip rtp 10.10.10.1 source-voice 1/0:1 codec g711u
timeout 10000
exit
ip sla sch 1 star now life 300
Workaround: There is no workaround. 
CSCse90580
Symptoms: A Cisco router may crash due to a bus error while removing the ip flow egress command 
from an interface.
Conditions: The router must have the ip flow egress command previously configured on the 
interface.
Workaround: There is no workaround. 
CSCsf32390
Symptoms: When tuning particle clone, F/S, and header pools after these were made configurable 
via CSCuk47328, the commands may be lost on a reload.
Conditions: If the device is reloaded the commands are not parsed on a reload and this results in the 
defaults being active. This may result in traffic loss if the increased buffers were needed to enable 
greater forwarding performance for the specific network design.