Cisco Cisco IOS Software Releases 12.2 MC
6
Release Notes for Cisco MWR 1941-DC Mobile Wireless Edge Router for Cisco IOS Release 12.2(15)MC1b
OL-13984-08
Limitations, Restrictions, and Important Notes
Cisco Network Modules
•
Alarm Interface Card—NM-AIC-64(=)
•
16-port Ethernet Switch—NM-16ESW(=)
Note
When using the NM-16ESW with the MWR 1941-DC router, shielded cables are required
and IP phone inline power is not supported.
and IP phone inline power is not supported.
•
Asynchronous
–
16-port Asynchronous Serial—NM-16A(=)
–
4-port Asynchronous/Synchronous Serial: NM-4A/S(=)
–
8-port Asynchronous/Synchronous Serial: NM-8A/S(=)
•
1-port T3/E3: NM-1T3/E3(=)
Limitations, Restrictions, and Important Notes
Caution
The Cisco MWR 1941-DC router does not support online insertion and removal (OIR) of WAN interface
cards. Any attempt to perform OIR on a card in a powered up router might cause damage to the card.
cards. Any attempt to perform OIR on a card in a powered up router might cause damage to the card.
Caution
The Cisco MWR 1941-DC router does not support online insertion and removal (OIR) of network
modules. Any attempt to perform OIR on a card in a powered up router might cause damage to the card.
modules. Any attempt to perform OIR on a card in a powered up router might cause damage to the card.
Caution
Removing the compact flash from the Cisco MWR 1941-DC router during a read/write operation might
corrupt the contents of the compact flash, rendering it useless. To recover from an accidental removal of
or corruption to the compact flash, a maintenance spare with the appropriate bootable Cisco IOS
software image might be needed.
corrupt the contents of the compact flash, rendering it useless. To recover from an accidental removal of
or corruption to the compact flash, a maintenance spare with the appropriate bootable Cisco IOS
software image might be needed.
Using the 1-port T3/E3: NM-1T3/E3(=)
When using the 1-port T3/E3 network module in your MWR 1941-DC router configuration, note that E3
mode is not supported with Cisco IOS Release 12.2(15)MC1a. E3 mode is supported with Cisco IOS
Release 12.2(15)MC1b and later.
mode is not supported with Cisco IOS Release 12.2(15)MC1a. E3 mode is supported with Cisco IOS
Release 12.2(15)MC1b and later.
Also, when used with the MWR 1941-DC router, the NM-1T3/E3 supports line rate throughput for traffic
with packet sizes of 1500 bytes. For traffic with smaller packet sizes, degradation in throughput will be
seen.
with packet sizes of 1500 bytes. For traffic with smaller packet sizes, degradation in throughput will be
seen.
Upgrading the VWIC-2MFT-T1-DIR Microcode
When upgrading the image on your Cisco MWR 1941-DC router, power cycle the router or perform a
microcode reload on the VWIC-2MFT-T1-DIR to ensure that the firmware for the VWIC-2MFT-T1-DIR
is updated during the upgrade.
microcode reload on the VWIC-2MFT-T1-DIR to ensure that the firmware for the VWIC-2MFT-T1-DIR
is updated during the upgrade.