Cisco Cisco IOS Software Releases 12.2 MC

 

This section contains information that was not included or was documented incorrectly in the 
MGX-RPM-1FE-CP Back Card Installation and Configuration Note. The heading in this section 
corresponds with the applicable section title in the documentation.

The efficiency improvement factor calculation documented in the show ppp mux command section is 
incorrect. The correct improvement factor calculation uses bytes, not packets, and is as follows:

Multiplex efficiency improvement factor = 100 * (Total bytes saved) / (Total bytes received)

Where total bytes saved = bytes_received_at_muxer - bytes_sent_at_muxer.

Demultiplex efficiency improvement factor = 100 * (Total bytes saved) / (Total bytes sent)

Where total bytes saved = bytes_sent_at_demuxer - bytes_received_at_demuxer.

The following sections describe the documentation available related to the Cisco MGX-RPM-1FE-CP 
back card.These documents consist of hardware and software installation guides, Cisco IOS 
configuration guides and command references, system error messages, and other documents.

Documentation is available as printed manuals or electronic documents.

These documents are available for the Cisco MWR 1900 Mobile Wireless Edge Router on Cisco.com 
and the Documentation CD-ROM: 

Cisco MWR 1900 Mobile Wireless Edge Router

Cisco MWR 1900 Software Configuration Guide 

Cisco MWR 1900 Rack Mounting Instructions 

Cisco MWR 1900 Regulatory Compliance and Safety Information