Manualsbrain.com
  1. Manuels
  2. Marques
  3. Cisco
  4. Cisco IOS Software Release 12.4(11)T

Cisco Cisco IOS Software Release 12.4(11)T

Télécharger
Page de 98
 
Integrated Data, Voice, and Video Services for ISDN Interfaces
  How to Configure Static and Dynamic H.320 Secondary Call Dial Plans
35
Integrating Data, Voice, and Video Services for ISDN Interfaces
Configuring Static Outbound POTS Dial Peers for Terminating Gateway
The outbound POTS dial peers on the terminating gateway handle outgoing H.320 primary and 
secondary calls. Configure separate dial peers for H.242 and nonH.242 endpoints.
The static outbound dial peer with routing dialed numbers terminates to nonH.242 endpoints. On the 
static outbound POTS dial peer, called numbers are allocated from the inbound called number table. 
Use the following steps to configure the static outbound POTS dial peer on the terminating gateway.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
dial-peer voice tag pots
4.
destination pattern [+] string [T]
5.
information-type [fax | video | voice]
6.
voice-class called-number [inbound | outbound] tag
7.
bandwidth maximum value minimum value
8.
no digit-strip (optional)
9.
trunkgroup name preference-num (optional)
DETAILED STEPS
Command or Action
Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode. 
•
Enter your password if prompted.
Step 2
configure
 terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
dial-peer voice 
tag pots
Example:
Router(config)# dial-peer voice 2222 pots
Defines a specific dial peer, specifies the method of voice 
encapsulation, and enters dial-peer configuration mode.
•
tag—Identifier for the dial peer. Range is 
1 to 2147483647.
•
pots—Indicates that this is a POTS peer that uses VoIP 
encapsulation on the IP backbone. 
Step 4
destination-pattern [+] 
string [T]
Example:
Router(config-dial-peer)# destination-pattern 
4085550100
Specifies either the prefix or the full E.164 telephone 
number to be used for a dial peer.