Cisco Cisco IOS Software Release 12.4(23)

Page de 610
519
Caveats for Cisco IOS Release 12.4
OL-7656-15 Rev. J0
  Resolved Caveats—Cisco IOS Release 12.4(8)
CSCsd81350
Symptoms: When asynchronous serial interfaces are used as member links in multilink PPP bundles, 
the router may crash due to memory corruption.
Conditions: This problem can occur under conditions where multilink fragmentation is done, and 
where the bundle includes at least one member link that is an asynchronous interface.
Workaround: Disable fragmentation on the bundle interface for any bundle that may include 
asynchronous links as members. Alternatively, if the use of multilink is not a requirement, disable 
multilink on the asynchronous interfaces. 
CSCse16539
Symptoms: VPDN loadbalancing incorrectly biases to one LNS (IP address) instead of sharing the 
session load between the different LNSs after LNS return from the busy list.
Conditions: This occurs when multiple LNSs are configured for one vpdn-group and are 
unreachable. They are moved to the busy list. Once the LNSs become reachable again, this problem 
occurs.
Workaround: There is no workaround. 
Resolved Caveats—Cisco IOS Release 12.4(8)
This section describes possibly unexpected behavior by Cisco IOS Release 12.4(8). All the caveats listed 
in this section are resolved in Cisco IOS Release 12.4(8). This section describes severity 1 and 2 caveats 
and select severity 3 caveats.
Basic System Services
CSCea36491
Symptoms: When a Telnet session is made to a router after a VTY session pauses indefinitely, the 
user in the Telnet session may not be able to enter the configuration mode. When these symptoms 
occur, interfaces may enter the wedged state with Simple Network Management Protocol (SNMP) 
traffic.
Conditions: This behavior is observed on ATM and Packet over SONET (POS) interfaces. This 
behavior is not platform-specific.
Workaround: Disable Simple Network Management Protocol (SNMP) configuration traps by 
entering the no snmp-server enable traps config global configuration command. 
CSCee41892
Symptoms: A VIP4-80 card may fail to load the Cisco IOS software image. When this situation 
occurs, the following error messages are generated:
%DBUS-3-SW_NOTRDY: DBUS software not ready after HARD_RESET, elapsed 13056, status 0x0
%DBUS-3-WCSLDERR: Slot 2, error loading WCS, status 0x4 cmd/data 0xDEAD pos 97
%DBUS-3-WCSLDERR: Slot 2, error loading WCS, status 0x4 cmd/data 0xDEAD pos 99
%UCODE-3-LDFAIL: Unable to download ucode from system image in slot 2, trying rom 
ucode
%RSP-3-NOSTART: No microcode for VIP4-80 RM7000 card, slot 2
Conditions: This symptom is observed on a Cisco 7500 series when you enter the microcode reload 
command.