Cisco Cisco IOS Software Release 12.4(22)XR Références techniques

To alter the default always-on service parameters, use the cdma pdsn a10always-on keepalive 
command in global configuration mode. To return to the default values, use the no form of this command.

cdma pdsn a10 always-on keepalive {interval 1-65535 [attempts 0-255] | attempts 0-255}

no cdma pdsn a10 always-on keepalive {interval 1-65535 [attempts 0-255] | attempts 0-255}

The Always On feature is enabled. The default value for interval is 3, and the default value for attempts 
is 3.

Global configuration

The duration in seconds, for which PDSN waits for the LCP echo response 
from peer before sending next LCP echo. The default value is 3seconds.

The number of times the LCP echo is sent before determining an always-on 
user is not reachable and tearing down the session after idle timer expiry. 
The default value is 3. Configuring this value to 0 is similar to ignoring the 
always-on property for the user. 

12.3(8)XW

This command was introduced.