Cisco Cisco IOS Software Release 12.4(2)XB6 Références techniques

To specify options for PDU formation, for uplink service flows, and to configure restrictions on the types 
of bandwidth request options that may be used, use the policy-transmission-request subcommand in 
service flow QoS information configuration submode. An attribute is enabled by setting the 
corresponding bit position to 1. Use the no form of the command to disable this functionality.

policy-transmission-request policy-transmission-request-value

There are no default values.

Service flow QoS information configuration submode.

An attribute is enabled by setting the corresponding bit position to 1.

The following example illustrates how to configure the policy-transmission-request subcommand:

wimax agw service-flow qos-info profile isf-qos-downlink  

data-delivery-service real-time-variable-rate  

maximum-latency 1  

maximum-traffic-burst 2  

maximum-traffic-rate-sustained 3  

media-flow-type 012041424344  

Specifies the value of the policy transmission request. 
Range of values is 0-4294967295 32-bit bitmask. 

Bit #0 Service flow shall not use broadcast bandwidth request 
opportunities.(Uplink only) 

Bit #1 Reserved.

Bit #2 The service flow shall not piggyback requests with data (Uplink 
only).

Bit #3 The service flow shall not fragment data.

Bit #4 The service flow shall not suppress payload headers (CS 
parameter).

Bit #5 The service flow shall not pack multiple SDUs (or fragments) into 
single MAC PDUs.

Bit #6 The service flow shall not include CRC in the MAC PDU.

All other bit positions are reserved.

12.4(15)XL

This command was introduced.