Cisco Cisco IOS Software Release 12.2(33)SRE

Workaround: Use other path option method such as dynamic path option, explicit with exclude 
address. 

CSCsv20768

Symptoms: The clock source will be shown as LINE and the Path Trace buffer as UNSTABLE.

Conditions: Occurs when you configure the clock source as INTERNAL under an ATM interface 
and do a SSO switchover.

Workaround: Perform a shut/no shut on the interface. 

CSCsv27234

Symptoms: Contr looped local, PPP interface line protocol down, should be line protocol down 
(looped)

Conditions: Occurs when T3 controller is put in local loopback and the clock source is line, the 
interfaces configured on that controller are not looped. For clock source internal it works fine.

Workaround: There is no workaround. 

CSCsv69906

Symptoms: Multilink bundles are in non-distributed state after a stateful switchover (SSO).

Conditions: Occurred on a Cisco 7600 with RSP 72043, SIP-200, and SPA-4xCT3.

Workaround: Perform a shut/no shut on the bundles that are in non-distributed state. 

CSCsv75792

Symptoms: Configured LI slot is not taking the active role after switchover.

router#sh li-slot The Configured slot list: 3 The active LI slot: 3 Configured rate: 

1000000 pps

router# router#redundancy force-switchover

This will reload the active unit and force switchover to standby[confirm]

Preparing for switchover..Connection closed by foreign host. router#sh li-slot The 

Configured slot list: 3 The active LI slot: RP rate: 8500 pps router#sh run | i 

li-slot li-slot list 3 rate 1000000 router#conf t router(config)#li-slot list 3 rate 

1000000 router(config)#^Z router#sh li-slot The Configured slot list: 3 The active LI 

slot: 3 Configured rate: 1000000 pps router#

Conditions: Occurs on routers running Cisco IOS Release 12.2(33)SRC2 and Cisco IOS Release 
12.2(33)SRD.

Workaround: Use li-slot list command after switchover. 

This section describes possibly unexpected behavior by Cisco IOS Release 12.2(33)SRC2. All the 
caveats listed in this section are open in Cisco IOS Release 12.2(33)SRC. This section describes only 
severity 1, severity 2, and select severity 3 caveats.

CSCsm97014

Symptoms: MLPoFR with the member group interface as crackerjack PA (PA-MC-2T3-EC) is 
configured. On applying a simple policy along with RTP header compression virtual template, the 
connectivity breaks.