Cisco Cisco IOS Software Release 12.2(33)SRE

Page de 298
170
Caveats for Cisco IOS Release 12.2(33)SRE through 12.2(33)SRE13
OL-10394-05 Rev. S1
  
Workaround: There is no workaround. 
CSCtb34814
Symptom: The following error message is reported just before a crash:
%DATACORRUPTION-1-DATAINCONSISTENCY: copy error
There may not be any tracebacks given for the crash.
Conditions: This symptom is observed under normal conditions.
Workaround: There is no workaround. 
CSCtd72271
Symptom: On an L3 port-channel with member interfaces of a 7600-ES+4TG3CXL module, after a 
member interface has recovered from a failure or when a shut/no shut is performed, this member 
interface starts flapping and the output traffic is dropped.
Conditions: This symptom occurs when a service policy is attached or VRF is configured on a 
port-channel interface and there are two members on it.
Workaround: Remove the service policy from the port-channel interface 
CSCtf31377
Symptom: IOS crashes due to processor pool memory corruption.
Conditions: This symptom occurs due to processor pool memory corruption. IOS generates one or 
more CLUE memory error messages similar to the following messages:
%CLUE-DFC3-3-SOR_CORRUPT: CLUE record corruption in start of record field, record id 
3341, record
starting address 0x5FFFFF90
This issue could also be seen on LAN cards of a Cisco 7600 router. 
Workaround: There is no workaround. 
CSCtj29261
Symptom: Customer received the following error messages on a Cisco ASR router:
%SYS-2-SHARED: Attempt to return buffer with sharecount 0
Conditions: This issue can occur when the Cisco ASR 1000 router receives STP packet because it 
is not yet supported on Cisco ASR 1000.
Workaround: Stop sending STP packet. 
CSCtj61284
Symptom: NAT overload does not work for non-directly connected destinations in MPLS-VPN 
configurations.
Conditions: The symptom is observed with NAT overload configured to NAT traffic coming over an 
MPLS VPN to internet (via a VRF-enabled interface).
Workaround: There is no workaround. 
CSCtk32299
Symptom: SVI state remains down.
Conditions: This symptom occurs when scaled MTP and SVI configurations are copied to the router.
Workaround: Unconfigure and configure MTP and SVI configurations.