Cisco Cisco IOS Software Release 12.2(33)SRE

To configure the delay that Resource Reservation Protocol (RSVP) uses before starting a fast local repair 
(FLR) procedure, use the ip rsvp signalling fast-local-repair wait-time command in interface 
configuration mode. To set the delay to its default, use the no form of this command.

ip rsvp signalling fast-local-repair wait-time interval 

This command is disabled by default; therefore, no delay is configured.

Interface configuration

Use the ip rsvp signalling fast-local-repair wait-time command to configure the delay desired in 
starting an FLR procedure. If you do not configure a delay, then path refreshes are triggered immediately 
after RSVP receives a route change notification from the routing information base (RIB).

The following example configures a delay of 100 ms:

Router(config-if)# ip rsvp signalling fast-local-repair wait-time 100

Amount of time before an FLR procedure begins, in milliseconds (ms). The 
range is 0 to 5000 ms. The default is 0.

12.2(33)SRB

This command was introduced.

Configures the number of notifications that are processed before RSVP 
suspends.

Configures the repair rate that RSVP uses for an FLR procedure.