Cisco Cisco IOS Software Release 12.2(35)SE

Release Notes for the Cisco ME 3400E and ME 3400 Ethernet Access Switches, Cisco IOS Release 12.2(50)SE and Later

OL-18265-05

Documentation Updates

Error Message UDLD-6-UDLD_PORT_RESET: UDLD reset interface [chars].

Error Message UFAST_MCAST_SW-3-PROC_START_ERROR: No process available for
transmitting UplinkFast packets.

Error Message UFAST_MCAST_SW-4-MEM_NOT_AVAILABLE: No memory is available for
transmitting UplinkFast packets on Vlan [dec].

Error Message VQPCLIENT-2-CHUNKFAIL: Could not allocate memory for VQP.

Error Message VQPCLIENT-2-DENY: Host [enet] denied on interface [chars].

Error Message VQPCLIENT-3-IFNAME: Invalid interface ([chars]) in response.

Updates to the ME 3400E Regulatory Compliance and Safety Information Guide
and the Getting Started Guide

These warnings were incorrectly documented in the guides. These are the correct warnings:

All Switches

Warning

This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than:
10 A Statement 1005

Cisco ME 3400EG-2CS-A

Warning

To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of:
140°F (60°C) Statement 1047

Cisco ME 3400E-24TS-M and Cisco ME 3400EG-12CS-M

Warning

To prevent the system from overheating, do not operate it in an area that exceeds the maximum
recommended ambient temperature of:
149°F (65°C) Statement 1047