Cisco Cisco IOS Software Release 12.2(35)SE
Americas Headquarters:
© 2007-2008 Cisco Systems, Inc. All rights reserved.
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Release Notes for the
Cisco Catalyst Blade Switch 3030,
Cisco IOS Release 12.2(40)SE1 and Later
Cisco Catalyst Blade Switch 3030,
Cisco IOS Release 12.2(40)SE1 and Later
Revised January 9, 2008
Cisco IOS Release 12.2(40)SE1 and 12.2(40)SE2 run on the Cisco Catalyst Blade Switch 3030.
Note
If you wish to use Device Manager to upgrade the switch from Cisco IOS Release 12.2(35)SE through
Cisco IOS Release 12.2(40)SE1 (the LAN Base image) to Cisco IOS Release 12.2(44)SE or later (the IP
base image), you must first upgrade to Cisco IOS Release 12.2(40)SE2.
Cisco IOS Release 12.2(40)SE1 (the LAN Base image) to Cisco IOS Release 12.2(44)SE or later (the IP
base image), you must first upgrade to Cisco IOS Release 12.2(40)SE2.
These release notes include important information about Cisco IOS Release 12.2(40)SE1 and any
limitations, restrictions, and caveats that apply to them. Verify that these release notes are correct for
your switch:
limitations, restrictions, and caveats that apply to them. Verify that these release notes are correct for
your switch:
•
If you are installing a new switch, see the Cisco IOS release label on the rear panel of your switch.
•
If your switch is on, use the show version privileged EXEC command. See the
•
If you are upgrading to a new release, see the software upgrade filename for the software version.
See the
See the
For the complete list of Cisco Catalyst Blade Switch 3030 documentation and of Cisco EtherSwitch
service module documentation, see the
service module documentation, see the
.
You can download the switch software from this site (registered Cisco.com users with a login password):
Contents
This information is in the release notes:
•
•