Cisco Cisco IOS Software Release 12.2(35)SE
Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Release Notes for Cisco Catalyst Switch Module
3110G, 3110X, and 3012 for IBM BladeCenter,
Cisco IOS Release 12.2(46)SE
3110G, 3110X, and 3012 for IBM BladeCenter,
Cisco IOS Release 12.2(46)SE
August 28, 2008
Cisco IOS Release 12.2(46)SE runs only on Catalyst Switch Module 3110G, 3110X, and 3012.
These release notes include important information about Cisco IOS Release 12.2(46)SE and any
limitations, restrictions, and caveats that apply to it. Verify that these release notes are correct for your
switch module:
limitations, restrictions, and caveats that apply to it. Verify that these release notes are correct for your
switch module:
•
If you are installing a new switch module, see the Cisco IOS release label on the rear panel of your
switch module.
switch module.
•
If your switch module is on, use the show version privileged EXEC command. See the
•
If you are upgrading to a new release, see the software upgrade filename for the software version.
See the
See the
You can download the switch module software from these sites (registered Cisco.com users with a login
password):
password):
This software release is part of a special release of Cisco IOS software that is not released on the same
maintenance cycle that is used for other platforms. As maintenance releases and future software releases
become available, they will be posted to Cisco.com in the Cisco IOS software area, and on the IBM
support page.
maintenance cycle that is used for other platforms. As maintenance releases and future software releases
become available, they will be posted to Cisco.com in the Cisco IOS software area, and on the IBM
support page.
For the complete list of Catalyst Switch Module 3110G, 3110X, and 3012 for IBM BladeCenter
documentation, see the
documentation, see the
.