Cisco Cisco IOS Software Release 12.2(35)SE

For /directory/image-name.tar, specify the directory (optional) and the image to download. Directory 
and image names are case sensitive.

This example shows how to download an image from a TFTP server at 198.30.20.19 and to overwrite 
the image on the switch:

Switch# archive download-sw /overwrite 

You can also download the image file from the TFTP server to the switch and keep the current image by 
replacing the /overwrite option with the /leave-old-sw option.

For additional recovery procedures, see the “Troubleshooting” chapter in the software configuration 
guide for this release.

You can assign IP information to your switch by using these methods:

The CLI-based setup program, as described in the hardware installation guide.

The DHCP-based autoconfiguration, as described in the software configuration guide.

Manually assigning an IP address, as described in the software configuration guide.

These are the new software features for this release:

Support for HSRP Version 2 (HSRPv2)

Disabling MAC address learning on a VLAN

PAgP Interaction with Virtual Switches and Dual-Active Detection, also referred to as enhanced 
PAgP

DHCP server port-based address allocation for the preassignment of an IP address to a switch port.

IPv6 default router preference (DRP) for improving the ability of a host to select an appropriate 
router

Generic message authentication support with the SSH Protocol and compliance with RFC 4256