Cisco Cisco IOS Software Release 12.2(27)SBC
Multiclass Multilink PPP
How to Configure Multiclass Multilink PPP
4
Multiclass Multilink PPP
10.
ppp multilink multiclass remote {apply [minimum min-value] | reject | ignore}
11.
no cdp enable
12.
exit
DETAILED STEPS
Command or Action
Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
•
Enter your password if prompted.
Step 2
configure
terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
interface multilink
multilink-bundle-number
Example:
Router(config)# interface multilink 1
Creates a multilink bundle and enters interface
configuration mode.
configuration mode.
•
multilink-bundle-number—Number of the multilink
bundle (a nonzero number).
bundle (a nonzero number).
Step 4
ip address
ip_address mask
Example:
Router(config-if)# ip address 10.0.0.161
255.255.255.240
Assigns an IP address and subnet mask to the bundle.
Step 5
ppp multilink
Example:
Router(config-if)# ppp multilink
Enables multilink PPP on an interface.
Step 6
ppp multilink interleave
Example:
Router(config-if)# ppp multilink interleave
Enables interleaving of packets among the fragments of
larger packets on a multiclass multilink PPP bundle.
larger packets on a multiclass multilink PPP bundle.
Step 7
ppp multilink fragment delay
milliseconds
[microseconds]
Example:
Router(config-if)# ppp multilink fragment delay
0 500
(Optional) Specifies a maximum time for the transmission
of a packet fragment on a multiclass multilink PPP bundle.
of a packet fragment on a multiclass multilink PPP bundle.
•
milliseconds—Valid range is from 0 to 1000
milliseconds. The default is 30 milliseconds.
milliseconds. The default is 30 milliseconds.
•
microseconds—Valid range is from 0 to 999
microseconds. The default is 0 milliseconds.
microseconds. The default is 0 milliseconds.