Cisco Cisco IOS Software Release 12.2(27)SBC
PPPoE Agent Remote-ID and DSL Line Characteristics Enhancement
Configuration Examples for the PPPoE Agent Remote-ID and DSL Line Characteristics Enhancement
7
PPPoE Agent Remote ID and DSL Line Characteristics Enhancement
DETAILED STEPS
Troubleshooting Tip
When the radius-server attribute 31 remote-id global configuration command is entered in the PPPoE
Agent Remote-ID Tag and DSL Line Characteristics feature configuration on the BRAS, the debug
radius privileged EXEC command can be used to generate a report that includes information about the
incoming access interface, where discovery frames are received, and about the session being established
in PPPoE extended NAS-Port format (format d).
Agent Remote-ID Tag and DSL Line Characteristics feature configuration on the BRAS, the debug
radius privileged EXEC command can be used to generate a report that includes information about the
incoming access interface, where discovery frames are received, and about the session being established
in PPPoE extended NAS-Port format (format d).
Configuration Examples for the PPPoE Agent Remote-ID and DSL
Line Characteristics Enhancement
Line Characteristics Enhancement
This section contains the following examples:
•
•
Command or Action
Purpose
Step 1
enable
Example:
Router> enable
Enables privileged EXEC mode.
•
Enter your password if prompted.
Step 2
configure
terminal
Example:
Router# configure terminal
Enters global configuration mode.
Step 3
bba-group pppoe
group-name
Example:
Router(config)# bba-group pppoe pppoe-group
Defines a PPPoE profile and enters BBA group
configuration mode.
configuration mode.
Step 4
vendor-tag strip
Example:
Router(config-bba-group)# vendor-tag strip
Enables the BRAS to strip off incoming vendor-specific
tags (including Remote-ID, DSL-Sync-Rate tags, and
Circuit-ID) from outgoing PADO and PADS frames.
tags (including Remote-ID, DSL-Sync-Rate tags, and
Circuit-ID) from outgoing PADO and PADS frames.
Note
Starting in Cisco IOS Release 12.2(31)SB2, the
vendor-tag strip command replaces the vendor-tag
circuit-id strip command.
vendor-tag strip command replaces the vendor-tag
circuit-id strip command.