Cisco Cisco IOS Software Release 12.2(27)SBC
1
Cisco IOS Release 12.2(31)SB2
Link Aggregation Control Protocol (LACP)
(802.3ad) for Gigabit Interfaces
(802.3ad) for Gigabit Interfaces
First Published: November, 2006
Revised: March, 2007
Revised: March, 2007
This document describes how to configure Gigabit Ethernet port channels using LACP. This allows you
to bundle multiple Gigabit Ethernet links into a single logical interface on a Cisco 10000 series router.
to bundle multiple Gigabit Ethernet links into a single logical interface on a Cisco 10000 series router.
Finding Feature Information in This Module
Your Cisco IOS software release may not support all of the features documented in this module. To reach
links to specific feature documentation in this module and to see a list of the releases in which each feature is
supported, use the
links to specific feature documentation in this module and to see a list of the releases in which each feature is
supported, use the
Finding Support Information for Platforms and Cisco IOS Software Images
Use Cisco Feature Navigator to find information about platform support and Cisco IOS software image
support. Access Cisco Feature Navigator at http://www.cisco.com/go/fn. You must have an account on
Cisco.com. If you do not have an account or have forgotten your username or password, click Cancel at
the login dialog box and follow the instructions that appear.
support. Access Cisco Feature Navigator at http://www.cisco.com/go/fn. You must have an account on
Cisco.com. If you do not have an account or have forgotten your username or password, click Cancel at
the login dialog box and follow the instructions that appear.
Contents
•
•
•
•
•
•
•
•
Prerequisites for LACP (802.3ad) for Gigabit Interfaces
This feature requires a Performance Routing Engine 2 (PRE2) or PRE3.