Cisco Cisco IOS Software Release 12.2(55)SE
16
Release Notes for the Cisco IE 3000 Switch, Cisco IOS Release 12.2(55)SE and Later
OL-23061-05
Resolved Caveats
•
CSCuj77426
After running the shutdown command followed by the no shutdown command on the switch, few
ports go into not connected state even though these are connected to a remote device.
ports go into not connected state even though these are connected to a remote device.
The workaround is to run the shutdown command followed by the no shutdown command on the
affected ports.
affected ports.
•
CSCtx37546
After stack switchover length 0 automatically gets set to line vty on stack master or member.
There is no workaround.
•
CSCsv29870
When Routing Information Protocol (RIP) is configured and clear ip route* command is run on the
switch, the RIP sends multiple requests for each interface instead of one request.
switch, the RIP sends multiple requests for each interface instead of one request.
There is no workaround.
•
CSCue94493
When Cisco IP Communicator (CIPC) is turned on and the Cisco Discovery Protocol (CDP) is
enabled on the switch, the MAC address of CIPC incorrectly appears in the voice VLAN.
enabled on the switch, the MAC address of CIPC incorrectly appears in the voice VLAN.
The workaround is to disable CDP on Cisco IP Communicator.
•
CSCuh80308
When Access Control List (ACL) entries are applied to the switch interface using copy tftp:
running-config command, it stops forwarding fragmented traffic.
running-config command, it stops forwarding fragmented traffic.
Use one of the following workarounds:
–
Apply the ACL configuration through CLI.
–
Remove the ACL from the interface and apply again through the CLI.
–
In the ACL specify the traffic using IP addresses.
•
CSCsw43080
For Cisco IOS Releases earlier than 12.4(24)T, traceback and
%DATACORRUPTION-1-DATAINCONSISTENCY
errors are observed in the log.
There is no workaround.
•
CSCuh72558
In a switch stack, if a stack member is connected to a Meru access point that requires 802.3at or
29.5W POE+ inline power, connection over 802.3at POE+ fails.
29.5W POE+ inline power, connection over 802.3at POE+ fails.
The workaround is to move all affected POE+ devices to the stack master.
•
CSCui56736
This issue is seen on Cisco IOS Releases 12.2(55)SE and later, 12.2(58)SE and later, and 15.0(2)SE
and later. When the switch stack is reloaded, configuration is initialized, the vlan.dat file is deleted,
and VTP version 3 is configured, the show vtp status command gives inconsistent results on the
stack master and member switches. When the command is run on the stack master, the stack master
is shown as server in the VLAN and transparent in the Multiple Spanning Tree (MST) instance. But
when the command is run on a member switch, the member switch is shown as the primary server
for both the VLAN and the MST instance. When the vtp mode transparent mst command is
and later. When the switch stack is reloaded, configuration is initialized, the vlan.dat file is deleted,
and VTP version 3 is configured, the show vtp status command gives inconsistent results on the
stack master and member switches. When the command is run on the stack master, the stack master
is shown as server in the VLAN and transparent in the Multiple Spanning Tree (MST) instance. But
when the command is run on a member switch, the member switch is shown as the primary server
for both the VLAN and the MST instance. When the vtp mode transparent mst command is