Cisco Cisco IOS Software Release 12.2(52)SE

Cisco IOS Release 12.2(52)SE runs only on Catalyst Switch Module 3110G, 3110X, and 3012.

These release notes include important information about Cisco IOS Release 12.2(52)SE and later and 
any limitations, restrictions, and caveats that apply to it. Verify that these release notes are correct for 
your switch module:

If you are installing a new switch module, see the Cisco IOS release label on the rear panel of your 
switch module.

If your switch module is on, use the show version privileged EXEC command. See the 

If you are upgrading to a new release, see the software upgrade filename for the software version. 
See the 

You can download the switch module software from these sites (registered Cisco.com users with a login 
password):

This software release is part of a special release of Cisco IOS software that is not released on the same 
maintenance cycle that is used for other platforms. As maintenance releases and future software releases 
become available, they will be posted to Cisco.com in the Cisco IOS software area, and on the IBM 
support page.

For the complete list of Catalyst Switch Module 3110G, 3110X, and 3012 for IBM BladeCenter 
documentation, see the 

.