Cisco Cisco IOS XE 3.5E Manuel Technique
Catalyst 3850 Series Switch with Embedded
Wireshark Configuration Example
Wireshark Configuration Example
Document ID: 117639
Contributed by Colby Beam, Cisco TAC Engineer.
Apr 22, 2014
Apr 22, 2014
Contents
Introduction
Prerequisites
Requirements
Components Used
Restrictions
Configure
Configuration Example
Confirm that the Status is Active
View the Capture
Verify
Troubleshoot
Capture Control−Plane Traffic
Configuration
Results
Prerequisites
Requirements
Components Used
Restrictions
Configure
Configuration Example
Confirm that the Status is Active
View the Capture
Verify
Troubleshoot
Capture Control−Plane Traffic
Configuration
Results
Introduction
This document describes how to use the embedded Wireshark feature of the Cisco Catalyst 3850 Series
Switch that runs Version 3.3.0 or later in order to capture packets that ingress or egress the switch.
Switch that runs Version 3.3.0 or later in order to capture packets that ingress or egress the switch.
Prerequisites
Requirements
Cisco recommends that you have knowledge of Wireshark.
Components Used
The information in this document is based on the Cisco Catalyst 3850 Series Switch that runs Version 3.3.0 or
later.
later.
Restrictions
License: Requires IPBASE or IPSERVICES.
•
Capture filters are not supported.
•
Layer 2 and Layer 3 EtherChannels are not supported.
•
MAC Access Control List (ACL) is only used for non−IP packets such as ARP. It is not supported on
a Layer 3 port or Switch Virtual Interface (SVI).
a Layer 3 port or Switch Virtual Interface (SVI).
•
During a Wireshark packet capture, hardware forwarding happens concurrently.
•