Cisco Cisco IOS XE 3.5E Manuel Technique
WPA2-PSK and Open Authentication with Cisco
5760 WLC Configuration Example
5760 WLC Configuration Example
Document ID: 116880
Contributed by Surendra BG, Cisco TAC Engineer.
Nov 05, 2015
Nov 05, 2015
Contents
Introduction
Prerequisites
Requirements
Components Used
Configure
Network Diagram
WPA2-PSK Configuration with CLI
WPA2-PSK Configuration with GUI
Open Authentication Configuration with CLI
Open Authentication Configuration with GUI
Verify
Troubleshoot
Prerequisites
Requirements
Components Used
Configure
Network Diagram
WPA2-PSK Configuration with CLI
WPA2-PSK Configuration with GUI
Open Authentication Configuration with CLI
Open Authentication Configuration with GUI
Verify
Troubleshoot
Introduction
This document explains the advantages of the use of Wi-Fi Protected Access 2 (WPA2) in a Wireless LAN
(WLAN). The document provides two configuration examples for the implementation of WPA2 on a WLAN:
(WLAN). The document provides two configuration examples for the implementation of WPA2 on a WLAN:
Configuration of a WPA2 Pre-Shared Key (PSK)
•
Configuration of open authentication
•
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Wireless Protected Access (WPA)
•
WLAN security solutions
•
Components Used
The information in this document is based on these software and hardware versions:
A Cisco 5700 Series Wireless LAN Controller (WLC) with Cisco IOS
®
XE Software, Release 3.3
•
Cisco Aironet 3600 Series Lightweight Access Point
•
Microsoft Windows 7 native wireless supplicant
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
devices used in this document started with a cleared (default) configuration. If your network is live, make sure