Cisco Cisco Aironet 1522 Lightweight Outdoor Mesh Access Point Guide De Conception
138
Cisco Aironet 1520, 1130, 1240 Series Wireless Mesh Access Points, Design and Deployment Guide, Release 6.0
OL-20213-01
Troubleshooting
Mesh Access Point Debug Commands
You can enter these commands directly on the mesh access point using the AP console port or you can
use the remote debug feature from the controller.
use the remote debug feature from the controller.
•
debug mesh ethernet bridging—Debugs Ethernet bridging.
•
debug mesh ethernet config—Debugs access and trunk port configuration associated with VLAN
tagging.
tagging.
•
debug mesh ethernet registration—Debugs VLAN registration protocol. Associated with VLAN
tagging.
tagging.
•
debug mesh forwarding table—Debugs the forwarding table containing bridge groups.
•
debugs mesh forwarding packet bridge-group—Debugs bridge group configuration.
Mesh Access Point Roles
By default, the AP1520s are shipped with a radio role set to MAP. Therefore, you must change the radio
role on a mesh access point for it to function as RAP.
role on a mesh access point for it to function as RAP.
You can change this configuration on the mesh access point by statically setting them as rooftop access
points or mesh access points with the following command:
points or mesh access points with the following command:
(Cisco Controller) > config ap role {rootAP | mesh AP | default}
To change the radio role can also be changed using the GUI,:
1.
Click Wireless > Access Points > All APs to open the All APs window.
2.
Click the name of the mesh access point that you want to change. Click Mesh tab.
3.
From the AP Role drop-down menu, choose MeshAP or RootAP to specify this mesh access point
as a MAP or RAP, respectively.
as a MAP or RAP, respectively.
4.
Click Apply to commit your changes. The mesh access point reboots.