Cisco Cisco 3365 Mobility Services Engine
14
Release Notes for Cisco Mobility Services Engine, Release 8.0.100.0
OL-32458-01
Upgrading the MSE
This unpack yields the following three files. These three files must be in the same directory when
running the installer. The installation process uses the MSE_PUB.pem and signhash.bin to validate the
integrity of the MSE image.
running the installer. The installation process uses the MSE_PUB.pem and signhash.bin to validate the
integrity of the MSE image.
•
Cisco-MSE-L-K9-8-0-100-0-64bit.bin
•
MSE_PUB.pem
•
signhash.bin
Note
If the MSE image file was transfered directly to the MSE and not downloaded using PI, then the
following command should be used to decompress and unpack the installer files:
tar zxvf ../CISCO-MSE-L-K9-8-0-100-0.bin.tar.gz
following command should be used to decompress and unpack the installer files:
tar zxvf ../CISCO-MSE-L-K9-8-0-100-0.bin.tar.gz
Step 12
Make sure that the CISCO-MSE-L-K9-8-0-100-0-64bit.bin file has execute permissions for
the root user. If not, enter the following command:
the root user. If not, enter the following command:
chmod +x CISCO-MSE-L-K9-8-0-100-0-64bit.bin
Step 13
Manually stop the MSE service using the following command:
/etc/init.d/msed stop
or service msed stop
Step 14
To install the new Mobility Services Engine image, enter the following command:
/opt/installers/8.0.100.0/CISCO-MSE-L-K9-8-0-100-0-64bit.bin
Note
The installation process takes a minimum of 30 minutes. The actual installation time depends on the
amount of data present in your system. After the installation, you need to reboot the system before
starting the MSE.
amount of data present in your system. After the installation, you need to reboot the system before
starting the MSE.
Step 15
Start the new Mobility Services Engine software by entering the following command. If you attempt to
start the MSE, it just returns an error saying that MSE needs to be rebooted.
start the MSE, it just returns an error saying that MSE needs to be rebooted.
/etc/init.d/msed start
Step 16
The system must be rebooted after upgrading the MSE. After exiting the installer, enter the command
reboot
reboot
at the prompt to reboot the MSE.
Restoring an Old Database to 8.0.100.0
To restore an old database, follow these steps:
Note
The regular Restore option on the Prime Infrastructure cannot be used to restore a backup from an older
MSE releases such as 6.0, 7.0.105.0, or 7.0.110.0 onto 8.0.100.0.
MSE releases such as 6.0, 7.0.105.0, or 7.0.110.0 onto 8.0.100.0.
Step 1
Stop the MSE service: /etc/init.d/msed stop
Step 2
Uninstall the software and select to delete the database.
Step 3
To restore the backup data, you must first install the appropriate version of MSE software. Use the table
below to determine the correct version of MSE to install.
below to determine the correct version of MSE to install.