Cisco Cisco 4404 Wireless LAN Controller
10
Release Notes for Cisco Wireless LAN Controllers and Mesh Access Points for Release 4.1.190.5
OL-31336-01
System Requirements
Upgrading to this Software Release
For instructions on downloading software to the controller using either Cisco WCS or the controller GUI
or CLI, refer to the release 4.1 versions of the Cisco Wireless Control System Configuration Guide and
the Cisco Wireless LAN Controller Configuration Guide.
or CLI, refer to the release 4.1 versions of the Cisco Wireless Control System Configuration Guide and
the Cisco Wireless LAN Controller Configuration Guide.
Click this link to access those documents:
Upgrade Path to Release 4.1.190.5
Details for upgrading your network to Release 4.1.190.5 from earlier releases of 3.1, 3.2, 4.0 and 4.1 are
described below.
described below.
•
If your controller is installed with release 4.0.2xx software, you must upgrade to a version of release
4.1 (4.1.171.0, 4.1.185.0 or later) prior to upgrading to Release 4.1.190.5.
4.1 (4.1.171.0, 4.1.185.0 or later) prior to upgrading to Release 4.1.190.5.
•
If your controller is installed with release 4.0.1.xx or 3.2.xx, you must upgrade with two
intermediate releases prior to installing Release 4.1.190.5.
intermediate releases prior to installing Release 4.1.190.5.
–
First, upgrade to 4.0.217.0
–
Secondly, upgrade to 4.1.18x.x
–
Thirdly, upgrade to Release 4.1.190.5
•
If your controller is installed with release 3.1.x, you must upgrade with three intermediate releases
prior to installing Release 4.1.190.5.
prior to installing Release 4.1.190.5.
–
First, upgrade to 3.2.195.10
–
Secondly, upgrade to 4.0.217.0
–
Thirdly, upgrade to 4.1.18x.0
–
Fourthly, upgrade to Release 4.1.190.5
Mandatory Boot Variable Update for Networks with 1520s
If your network is operating with 1520s or you plan to install 1520s in your network, you must set the
boot variable on the 1520 BEFORE upgrading from release 4.1.190.5 to 4.1.191.24M (or greater mesh
release). Updating the boot variable ensures the 1520 joins correctly.
boot variable on the 1520 BEFORE upgrading from release 4.1.190.5 to 4.1.191.24M (or greater mesh
release). Updating the boot variable ensures the 1520 joins correctly.
Note
You should check the boot variable setting before updating the boot.
•
If the boot system image is visible, then no boot variable update is required.
–
For release 4.1.190.5, the system image should read:
flash:/c1520-k9w9-mx.124-3g.JMA1/c1520-k9w9-mx.124-3g.JMA1
flash:/c1520-k9w9-mx.124-3g.JMA1/c1520-k9w9-mx.124-3g.JMA1
•
If the boot system image is missing, then you must update the boot variable.